Wall-mounted refrigeration monoblock for a positive-temperature cold room IMPAFRI CMVARN2026, R455A, 1891 W

IMPAFRI CMVARN2026 is an autonomous wall-mounted monoblock for a positive-temperature cold room. It uses R455A refrigerant (A2L class, GWP 146). Select the unit according to room temperature, volume and the actual heat load.

Cooling capacity and recommended cold-room volume

Manufacturer-declared ratings at +35 °C ambient temperature. These are preliminary selection values, not a substitute for a room-specific heat-load calculation.

Installation and dimensions

Wall-mounted Drop-in installation (sizes 1–3, manufacturer p. 259). Manufacturer size series: 2. Catalog supply rating: 230 V.

Lettered dimensions A–N correspond to the 2026 manufacturer catalog installation drawing. They must not be interpreted as universal panel cut-out dimensions. Confirm the exact opening, insulation thickness and service clearances for this unit.

Standard equipment and controls

Factory-assembled refrigeration circuit charged with R455A (A2L), a hermetic reciprocating compressor, a high-pressure safety switch and a thermostatic expansion valve. Standard protection includes a circuit breaker; defrost uses hot-gas injection. The unit features a condensate drain pan with automatic condensate evaporation and a 50 mm polyurethane-insulated evaporator enclosure.

XW270K controller: remote electronic control with maximum/minimum temperature recording, the Jet Cool rapid-cooling function and a night-time operation mode.

Cold-room accessories included: LED lighting and door micro-switch connection cable. The door micro-switch itself is a separately selectable accessory if required.

Factory options

Optional variants list additional factory accessories shown for this model in the catalog. Confirm accessory compatibility, duct and fan dependencies and final factory surcharges before ordering. Unconfirmed voltage conversions are excluded.

Exhausting condenser heat through ductwork. The standard axial condenser fan is intended for free-air discharge and cannot overcome duct resistance reliably. To extract warm condenser air through a duct, select the optional centrifugal condenser fan with vertical discharge. IMPAFRI duct-sizing guidance allows up to 20 m equivalent duct length: each 90° bend counts as 5 m of straight duct. With two such bends, for example, no more than 10 m of straight duct remains. Depending on the connection, a circular duct adaptor and a non-return damper may be needed. Ensure sufficient make-up air and verify duct dimensions and total pressure loss against available fan static pressure.

Operation and delivery

R455A is an A2L-class refrigerant. Selection, electrical connection, installation and commissioning must be reviewed by a qualified refrigeration specialist. The cold-room enclosure, fitting, commissioning and unloading are not included in the unit price unless otherwise stated in the quotation. Made to order; lead time 4–6 weeks.